Description
In the Linux kernel, the following vulnerability has been resolved:
flow_dissector: check device type before reading ETH_ADDRS
__skb_flow_dissect() unconditionally reads 12 bytes from eth_hdr(skb)
when FLOW_DISSECTOR_KEY_ETH_ADDRS is requested. This assumes the skb
has a valid Ethernet header at mac_header, which is not always the case.
The problem can be triggered by:
1. Creating a TUN device in L3 mode (IFF_TUN, hard_header_len=0)
2. Attaching a multiq qdisc with a flower filter matching on eth_src
3. Sending a packet through AF_PACKET
Since TUN in L3 mode has no link-layer header, mac_header points to
the L3 data area. The flow dissector reads 12 bytes of uninitialized
skb memory, which then propagates through fl_set_masked_key() and is
used as a rhashtable lookup key in __fl_lookup(), as reported by KMSAN.
Rejecting the filter in the control path (at tc filter add time) is
not feasible because TC filter blocks can be shared between arbitrary
devices -- a filter installed on an Ethernet device may later classify
packets on a headerless device through a shared block. The device
association is not fixed at filter creation time.
Fix this by gating the memcpy on dev->type == ARPHRD_ETHER, which
ensures only true Ethernet-framed packets have their addresses read.
This is more precise than the previous hard_header_len >= 12 check,
which would incorrectly pass for non-Ethernet link types like IPoIB
(ARPHRD_INFINIBAND, hard_header_len=24) and FDDI (hard_header_len=21)
whose L2 headers are not in Ethernet format. Additionally check
skb_mac_header_was_set() to guard against the pathological case where
mac_header is the unset sentinel (~0U), which would cause eth_hdr() to
return a wild pointer.
For the act_mirred redirect case (Ethernet packet redirected to a
non-Ethernet device sharing a TC block), zeroing the key is the correct
behavior: the packet is now being classified on the target device, where
Ethernet address matching is not semantically meaningful.
Note: on non-Ethernet devices, the zeroed key will match a filter
configured with all-zero MAC addresses. This is an improvement over the
previous behavior where uninitialized memory could randomly match any
filter.
flow_dissector: check device type before reading ETH_ADDRS
__skb_flow_dissect() unconditionally reads 12 bytes from eth_hdr(skb)
when FLOW_DISSECTOR_KEY_ETH_ADDRS is requested. This assumes the skb
has a valid Ethernet header at mac_header, which is not always the case.
The problem can be triggered by:
1. Creating a TUN device in L3 mode (IFF_TUN, hard_header_len=0)
2. Attaching a multiq qdisc with a flower filter matching on eth_src
3. Sending a packet through AF_PACKET
Since TUN in L3 mode has no link-layer header, mac_header points to
the L3 data area. The flow dissector reads 12 bytes of uninitialized
skb memory, which then propagates through fl_set_masked_key() and is
used as a rhashtable lookup key in __fl_lookup(), as reported by KMSAN.
Rejecting the filter in the control path (at tc filter add time) is
not feasible because TC filter blocks can be shared between arbitrary
devices -- a filter installed on an Ethernet device may later classify
packets on a headerless device through a shared block. The device
association is not fixed at filter creation time.
Fix this by gating the memcpy on dev->type == ARPHRD_ETHER, which
ensures only true Ethernet-framed packets have their addresses read.
This is more precise than the previous hard_header_len >= 12 check,
which would incorrectly pass for non-Ethernet link types like IPoIB
(ARPHRD_INFINIBAND, hard_header_len=24) and FDDI (hard_header_len=21)
whose L2 headers are not in Ethernet format. Additionally check
skb_mac_header_was_set() to guard against the pathological case where
mac_header is the unset sentinel (~0U), which would cause eth_hdr() to
return a wild pointer.
For the act_mirred redirect case (Ethernet packet redirected to a
non-Ethernet device sharing a TC block), zeroing the key is the correct
behavior: the packet is now being classified on the target device, where
Ethernet address matching is not semantically meaningful.
Note: on non-Ethernet devices, the zeroed key will match a filter
configured with all-zero MAC addresses. This is an improvement over the
previous behavior where uninitialized memory could randomly match any
filter.
Published:
2026-08-15
Score:
n/a
EPSS:
< 1% Very Low
KEV:
No
Impact:
n/a
Action:
n/a
Analysis
Analysis and contextual insights are available on OpenCVE Cloud.
Default status is the baseline for the product, each version can override it (e.g. patched versions marked unaffected).
| Vendor | Product | Default status | Versions | |||||||||||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| Linux | Linux | unaffected |
|
|||||||||||||||||||||||||||
| Linux | Linux | affected |
|
No data.
No data.
No data available yet.
Remediation
No vendor fix or workaround currently provided.
Additional remediation guidance may be available on OpenCVE Cloud.
Tracking
Sign in to view the affected projects.
Advisories
No advisories yet.
References
History
Sat, 15 Aug 2026 19:15:00 +0000
| Type | Values Removed | Values Added |
|---|---|---|
| Weaknesses | CWE-758 |
Sat, 15 Aug 2026 06:00:00 +0000
| Type | Values Removed | Values Added |
|---|---|---|
| Description | In the Linux kernel, the following vulnerability has been resolved: flow_dissector: check device type before reading ETH_ADDRS __skb_flow_dissect() unconditionally reads 12 bytes from eth_hdr(skb) when FLOW_DISSECTOR_KEY_ETH_ADDRS is requested. This assumes the skb has a valid Ethernet header at mac_header, which is not always the case. The problem can be triggered by: 1. Creating a TUN device in L3 mode (IFF_TUN, hard_header_len=0) 2. Attaching a multiq qdisc with a flower filter matching on eth_src 3. Sending a packet through AF_PACKET Since TUN in L3 mode has no link-layer header, mac_header points to the L3 data area. The flow dissector reads 12 bytes of uninitialized skb memory, which then propagates through fl_set_masked_key() and is used as a rhashtable lookup key in __fl_lookup(), as reported by KMSAN. Rejecting the filter in the control path (at tc filter add time) is not feasible because TC filter blocks can be shared between arbitrary devices -- a filter installed on an Ethernet device may later classify packets on a headerless device through a shared block. The device association is not fixed at filter creation time. Fix this by gating the memcpy on dev->type == ARPHRD_ETHER, which ensures only true Ethernet-framed packets have their addresses read. This is more precise than the previous hard_header_len >= 12 check, which would incorrectly pass for non-Ethernet link types like IPoIB (ARPHRD_INFINIBAND, hard_header_len=24) and FDDI (hard_header_len=21) whose L2 headers are not in Ethernet format. Additionally check skb_mac_header_was_set() to guard against the pathological case where mac_header is the unset sentinel (~0U), which would cause eth_hdr() to return a wild pointer. For the act_mirred redirect case (Ethernet packet redirected to a non-Ethernet device sharing a TC block), zeroing the key is the correct behavior: the packet is now being classified on the target device, where Ethernet address matching is not semantically meaningful. Note: on non-Ethernet devices, the zeroed key will match a filter configured with all-zero MAC addresses. This is an improvement over the previous behavior where uninitialized memory could randomly match any filter. | |
| Title | flow_dissector: check device type before reading ETH_ADDRS | |
| First Time appeared |
Linux
Linux linux Kernel |
|
| CPEs | cpe:2.3:o:linux:linux_kernel:*:*:*:*:*:*:*:* | |
| Vendors & Products |
Linux
Linux linux Kernel |
|
| References |
|
|
MITRE
Status: PUBLISHED
Assigner: Linux
Published:
Updated: 2026-08-15T05:56:55.229Z
Reserved: 2026-08-09T03:40:39.930Z
Link: CVE-2026-72444
Vulnrichment
No data.
NVD
Status : Received
Published: 2026-08-15T06:22:18.280
Modified: 2026-08-15T06:22:18.280
Link: CVE-2026-72444
Redhat
No data.
OpenCVE Enrichment
Updated: 2026-08-15T19:00:03Z
Weaknesses
-
CWE-758
Reliance on Undefined, Unspecified, or Implementation-Defined Behavior