| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
ntfs: not change 0-byte $DATA attribute to non-resident
When ntfs_resident_attr_resize() cannot grow a resident attribute in
place, it retries after converting other resident attributes to
non-resident to free space in the MFT recrord.
Do not select zero-length resident $DATA attributes for this conversion.
fsck treats 0-byte non-resident $DATA attribute as corruptions. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amdkfd: always resume_all after suspend_all
Need to restore any good queues even if the suspend_all
failed for some. Always run remove_queue as that will
schedule a GPU reset is removing the queue fails.
v2: move resume_all after remove |
| In the Linux kernel, the following vulnerability has been resolved:
net/sched: act_ct: preserve tc_skb_cb across defragmentation
tcf_ct_handle_fragments() calls nf_ct_handle_fragments() without saving
and restoring skb->cb. The defrag helper clears IPCB/IP6CB, which aliases
the tc_skb_cb/qdisc_skb_cb control buffer. Fragmented traffic through
act_ct therefore loses qdisc metadata such as pkt_segs and can trigger
WARN_ON_ONCE() in qdisc_pkt_segs() when panic_on_warn is enabled.
Save and restore the full tc_skb_cb around nf_ct_handle_fragments(),
matching the pattern used by ovs_ct_handle_fragments(). |
| In the Linux kernel, the following vulnerability has been resolved:
ipvs: use parsed transport offset in SCTP state lookup
set_sctp_state() reads the SCTP chunk header again in order to drive the
IPVS SCTP state table. For IPv6 it computes the offset with
sizeof(struct ipv6hdr), while the surrounding IPVS code uses iph.len from
ip_vs_fill_iph_skb(), where ipv6_find_hdr() has already skipped
extension headers and found the real transport header.
This makes the state machine read from the wrong offset for IPv6 SCTP
packets that carry extension headers. For example, an INIT packet with an
8-byte destination options header can be scheduled correctly by
sctp_conn_schedule(), but set_sctp_state() reads the first byte of the
SCTP verification tag as a DATA chunk type. The connection then moves
from NONE to ESTABLISHED instead of INIT1, gets the longer established
timeout, and updates the active/inactive destination counters
incorrectly. This happens even though the SCTP handshake has not
completed.
Use the parsed transport offset passed down from ip_vs_set_state() for
the SCTP chunk-header lookup. For IPv4 and IPv6 packets without
extension headers this preserves the existing offset. |
| The User Profile Builder plugin for WordPress is vulnerable to Authentication Bypass via Type Confusion in versions up to, and including, 3.16.4. This is due to the wppb_log_in_user() function calling absint() on the return value of wp_insert_user() before performing an is_wp_error() check — when a registration is submitted with a 61–70 character username, WordPress core rejects it with a WP_Error object, but absint() coerces that object to the integer 1 before the error check can short-circuit execution, causing the plugin to bind and return a transient-backed autologin nonce tied to user ID 1. This makes it possible for unauthenticated attackers to log in as the site's Administrator account (user ID 1), resulting in full administrative takeover of the site. |
| Russh is a Rust SSH client & server library. Prior to 0.62.4, a malicious SSH server can crash a russh client session with a malformed KEX_ECDH_REPLY containing a server ephemeral value that is not 32 bytes long. The client-side Curve25519Kex::compute_shared_secret function in russh/src/kex/curve25519.rs passes the decoded exchange.server_ephemeral value to clone_from_slice without validating its length, causing a deterministic panic before the server host key is verified. The panic terminates the spawned client session task and surfaces as a JoinError, while the embedding process normally remains running. This issue is fixed in version 0.62.4. |
| rsync before 3.5.0 contains a privilege confusion vulnerability in the name-converter subprocess uid/gid mapping that allows local attackers to cause transferred files to be owned by root by influencing name-converter responses to return empty values. When the name-converter subprocess returns an empty response for a uid or gid lookup, rsync incorrectly interprets it as a successful resolution to uid/gid 0 (root) rather than a lookup failure, and if the name-converter also signals fake super-user status, rsync proceeds with root ownership assignments for transferred files. |
| The dataplane token validator in kuma-cp performs an unchecked Go type assertion on the JWT kid header. A token whose kid is a JSON number decodes as a float64 and triggers a runtime panic before any signature, claims, or authorization check runs.
The panic terminates the entire kuma-cp process, HTTP API, the health and readiness endpoints, and xDS. Unauthenticated access to the dataplane gRPC server can trigger the crash with a malformed token
A single request is a transient interruption; sustaining an outage requires repeated requests. |
| An information leakage vulnerability was reported in the TCG TPM 2.0 reference code that could allow a local attacker with elevated privileges to obtain a credential from a TPM-aware CA for a falsified TPM key (such as an Attestation Key, DevID Key or TLS authentication key) and falsify other TPM 2.0 attestations with this key. See also TCG VRT0010. |
| In the Linux kernel, the following vulnerability has been resolved:
btrfs: do not try compression for data reloc inodes
[BUG]
There is a syzbot report that the check inside get_new_location()
triggered:
BTRFS info (device loop0): found 31 extents, stage: move data extents
BTRFS info (device loop0): leaf 8908800 gen 16 total ptrs 28 free space 1676 owner 18446744073709551607
item 0 key (256 INODE_ITEM 0) itemoff 3835 itemsize 160
inode generation 5 transid 0 size 0 nbytes 0
block group 0 mode 40755 links 1 uid 0 gid 0
rdev 0 sequence 0 flags 0x0
atime 1669132761.0
ctime 1669132761.0
mtime 1669132761.0
otime 0.0
item 1 key (256 INODE_REF 256) itemoff 3823 itemsize 12
index 0 name_len 2
item 2 key (258 INODE_ITEM 0) itemoff 3663 itemsize 160
inode generation 1 transid 16 size 733184 nbytes 106496
block group 0 mode 100600 links 0 uid 0 gid 0
rdev 0 sequence 24 flags 0x18
item 3 key (258 EXTENT_DATA 0) itemoff 3595 itemsize 68
generation 16 type 0
inline extent data size 47 ram_bytes 4096 compression 1
[...]
item 27 key (18446744073709551611 ORPHAN_ITEM 258) itemoff 2376 itemsize 0
BTRFS error (device loop0): unexpected non-zero offset in file extent item for data reloc inode 258 key offset 0 offset 9277520992061368337
------------[ cut here ]------------
btrfs_abort_should_print_stack(__error)
[CAUSE]
The above dump tree shows the first file extent item is inlined, which
should make no sense for data reloc inodes, as such inodes just
represent where the data extents are in the relocation destination chunk.
However the relocation path preallocates space for each block,
then dirties them, cluster by cluster.
It's possible to have a single block at the beginning of the block
group, and no other block in the same cluster.
So relocation will preallocate a file extent for that block and dirty
the first block. Then memory pressure forces the data reloc inode to be
written back, before any other blocks are dirtied/allocated.
Finally commit 3eaf5f082c4c ("btrfs: extract inlined creation into a dedicated
delalloc helper") changed the sequence of delalloc. Before that commit we
always tried NOCOW first, so that dirtied block would be written back into
the preallocated space, and appear as a regular extent.
But with that commit, we always try inline first, and since compression
is forced, we try compressing the first block, and then inline the
compressed data, resulting in the above inlined file extent in the data
reloc tree.
Then the check in get_new_location() will check the file offset, without
checking if the file extent is inlined or not, resulting in the above
failure.
[FIX]
Do not allow compression for data reloc inodes.
Since data reloc inode sizes are always block aligned, as long as we do
not compress, @data_len will always be at least one block, and
that will cause can_cow_file_range_inline() to return false, thus no
inlined extent will be created. |
| In the Linux kernel, the following vulnerability has been resolved:
net: dsa: fix a crash if ->get_sset_count() fails
If ds->ops->get_sset_count() fails then it "count" is a negative error
code such as -EOPNOTSUPP. Because "i" is an unsigned int, the negative
error code is type promoted to a very high value and the loop will
corrupt memory until the system crashes.
Fix this by checking for error codes and changing the type of "i" to
just int. |
| An issue was discovered in RISC-V PicoRV32 commit 87c89a. A mismatch in the PCPI INSN and memory address can lead to unexpected behavior. |
| In the Linux kernel, the following vulnerability has been resolved:
libceph: fix invalid accesses to ceph_connection_v1_info
There is a place where generic code in messenger.c is reading and
another place where it is writing to con->v1 union member without
checking that the union member is active (i.e. msgr1 is in use).
On 64-bit systems, con->v1.auth_retry overlaps with con->v2.out_iter,
so such a read is almost guaranteed to return a bogus value instead of
0 when msgr2 is in use. This ends up being fairly benign because the
side effect is just the invalidation of the authorizer and successive
fetching of new tickets.
con->v1.connect_seq overlaps with con->v2.conn_bufs and the fact that
it's being written to can cause more serious consequences, but luckily
it's not something that happens often. |
| In the Linux kernel, the following vulnerability has been resolved:
acpi: nfit: fix narrowing conversion in acpi_nfit_ctl
Syzkaller has reported a warning in to_nfit_bus_uuid(): "only secondary
bus families can be translated". This warning is emited if the argument
is equal to NVDIMM_BUS_FAMILY_NFIT == 0. Function acpi_nfit_ctl() first
verifies that a user-provided value call_pkg->nd_family of type u64 is
not equal to 0. Then the value is converted to int, and only after that
is compared to NVDIMM_BUS_FAMILY_MAX. This can lead to passing an invalid
argument to acpi_nfit_ctl(), if call_pkg->nd_family is non-zero, while
the lower 32 bits are zero.
Furthermore, it is best to return EINVAL immediately upon seeing the
invalid user input. The WARNING is insufficient to prevent further
undefined behavior based on other invalid user input.
All checks of the input value should be applied to the original variable
call_pkg->nd_family.
[iweiny: update commit message] |
| Incorrect type conversion or cast in Windows Notification allows an authorized attacker to elevate privileges locally. |
| Ledger Live with vulnerable versions of ledgerhq/hw-app-eth prior to 6.34.7 contains an integer parsing vulnerability that allows attackers to manipulate EIP-712 typed data messages by exploiting incorrect hexadecimal field parsing when values contain an odd number of characters. Attackers can obtain signatures on truncated or misinterpreted message values to authorize unintended blockchain transactions, such as asset transfers at incorrect amounts. |
| node-tar is a tar archive manipulation library for Node.js. Prior to 7.5.18, node-tar coerces all-digit PAX path and linkpath values in src/pax.ts to JavaScript numbers, causing downstream path handling such as normalizeWindowsPath(entry.path).split('/') to throw an uncaught TypeError. This issue is fixed in version 7.5.18. |
| Coder allows organizations to provision remote development environments via Terraform. Prior to versions 2.29.7, 2.32.7, 2.33.8, and 2.34.2, Coder's OIDC callback checked `email_verified` with a direct Go `bool` type assertion. When an IdP returned the claim as a non-boolean (for example the string `"false"`) or omitted it, the assertion failed open and the email was treated as verified. Combined with an unconditional email-based account fallback, this enabled account takeover. The fix in versions 2.29.7, 2.32.7, 2.33.8, and 2.34.2 coerces `email_verified` across bool, string and numeric types (fail-closed) and blocks the email fallback when the matched user already has a different linked IdP subject. As a workaround, ensure the IdP returns `email_verified` as a native JSON boolean. The email-fallback linking issue has no configuration workaround; upgrading is required. |
| A flaw was found in Keylime, a remote attestation solution, where strict type checking introduced in version 7.12.0 prevents the registrar from reading database entries created by previous versions, for example, 7.11.0. Specifically, older versions store agent registration data as bytes, whereas the updated registrar expects str. This issue leads to an exception when processing agent registration requests, causing the agent to fail. |
| In the Linux kernel, the following vulnerability has been resolved:
bpf: Switch CONFIG_CFI_CLANG to CONFIG_CFI
This was renamed in commit 23ef9d439769 ("kcfi: Rename CONFIG_CFI_CLANG
to CONFIG_CFI") as it is now a compiler-agnostic option. Using the wrong
name results in the code getting compiled out. Meaning the CFI failures
for btf_dtor_kfunc_t would still trigger. |
