| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
ata: libata-core: Add NOLPM quirk for PNY CS900 1TB SSD
The PNY CS900 1TB SSD (Phison PS3111-S11, DRAM-less) drops off the bus
after entering Device-Initiated Slumber during idle. With the default
med_power_with_dipm policy the link goes down (SStatus 1 SControl 300)
and does not recover, forcing the filesystem read-only. Forcing
max_performance keeps the link stable across prolonged idle.
Add a NOLPM quirk so link power management is disabled for this drive
specifically, leaving it intact for other devices on the host. |
| In the Linux kernel, the following vulnerability has been resolved:
batman-adv: tt: avoid request storms during pending request
batadv_send_tt_request() allocates a tt_req_node when none exists for the
destination originator node. This should prevent that a multiple TT
requests are send at the same time to an originator.
But if allocation of the send buffer failed, this request must be cleaned
up again. But indicator for such a failure is "ret == false". But the
actual implementation is checking for "ret == true".
The check must be inverted to not loose the information about the TT
request directly after it was attempted to be sent out. This should avoid
potential request storms. |
| In the Linux kernel, the following vulnerability has been resolved:
RDMA/bnxt_re: Proper rollback if the ioremap fails
bnxt_qplib_alloc_dpi returns success even if ioremap fails.
Add the proper rollback when the ioremap fails and return
-ENOMEM status. |
| A vulnerability has been found in SourceCodester Online Clothing Store 1.0. This affects an unknown part of the file /db/shopping.sql of the component SQL Database Backup. The manipulation leads to files or directories accessible. Remote exploitation of the attack is possible. The exploit has been disclosed to the public and may be used. |
| In the Linux kernel, the following vulnerability has been resolved:
iommufd: Destroy the pages content after detaching from dmabuf
Sashiko points out this has gotten out of order, the mutex could still be
in use through the dmabuf invalidation callbacks. Don't destroy any of the
pages content until the dmabuf is fully detached. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amdkfd: always resume_all after suspend_all
Need to restore any good queues even if the suspend_all
failed for some. Always run remove_queue as that will
schedule a GPU reset is removing the queue fails.
v2: move resume_all after remove |
| Exposure of data element to wrong session vulnerability in the JSON plugin of Apache Struts. Per-response serialization state could be shared across concurrent requests, allowing response content associated with one request to become observable in another. Only the SMD / JSON-RPC handling of the JSON interceptor is affected, which is not enabled by default; applications using the json result type are not affected.
This issue affects Apache Struts: 7.2.1.
Users are recommended to upgrade to version 7.3.0, which fixes the issue. |
| Exposure of data element to wrong session vulnerability in the JSON plugin of Apache Struts. Per-request parsing state could be shared across concurrent requests, allowing data associated with one request to become observable in another, and configured parsing limits not to be enforced as intended. Populating actions from a JSON request body is not enabled by default; applications that do not use the JSON plugin are not affected.
This issue affects Apache Struts: 7.2.1.
Users are recommended to upgrade to version 7.3.0, which fixes the issue. |
| In the Linux kernel, the following vulnerability has been resolved:
regulator: core: regulator_lock_two() should test for EDEADLK not EDEADLOCK
Compare against -EDEADLK, which is what ww_mutex_lock() actually
returns and what every other deadlock check in this file already uses.
Function regulator_lock_two() acquires two regulators via
regulator_lock_nested() -> ww_mutex_lock(). On contention,
ww_mutex_lock() returns -EDEADLK, which is the caller's signal to drop
the lock it holds and retry the acquisition in the canonical order.
However, regulator_lock_two() tests the return value against -EDEADLOCK
rather than -EDEADLK. On most architectures, EDEADLK and EDEADLOCK are
the same value, so the comparison happens to be correct and the bug is
invisible. But on MIPS, SPARC, and PowerPC, those two errors have
different values. The test is wrong: a genuine -EDEADLK backoff no
longer matches -EDEADLOCK, so instead of unlocking and retrying, the
code falls into WARN_ON(ret) and returns with only one of the two
regulators locked.
In practice, this is a bug only on MIPS, because the regulator core is
not built or used on the other two platforms.
In general, EDEADLK is preferred over EDEADLOCK for new code. |
| In the Linux kernel, the following vulnerability has been resolved:
ntfs: sanitize MFT references returned from ntfs_lookup_inode_by_name()
ntfs_lookup_inode_by_name() returns MFT references read from directory
index entries on disk. These values are untrusted, but the function can
currently return an error-marked MFT reference to its callers without
validating it.
Callers later decode lookup failures with MREF_ERR(). A crafted NTFS image
can set the MREF error bit while leaving the low bits as an arbitrary
value, causing callers to consume a bogus pseudo-errno instead of treating
the lookup result as corrupted on-disk metadata.
Fix this at the source by normalizing every error-marked MFT reference
returned from ntfs_lookup_inode_by_name() to ERR_MREF(-EIO). Apply this to
all four directory lookup return paths so every caller gets a validated
result without needing additional checks or an API change.
This keeps the sanitization in the common lookup helper, which is cleaner
than duplicating validation in each caller. |
| In the Linux kernel, the following vulnerability has been resolved:
spi: imx: reconfigure for PIO when DMA cannot be started
When spi_imx_can_dma() selects DMA, the ECSPI is configured for DMA:
spi_imx_setupxfer() sets CTRL.SMC and clears dynamic_burst, and
spi_imx_dma_transfer() programs the dynamic-burst BURST_LENGTH and the
SDMA watermarks.
If the DMA descriptor cannot be prepared (dmaengine_prep_slave_single()
returns NULL), the transfer is failed with SPI_TRANS_FAIL_NO_START and
falls back to PIO. The dynamic-burst DMA path uses its own bounce
buffers instead of the SPI core's mapping, so xfer->{tx,rx}_sg_mapped
are not set and the core's DMA->PIO retry is skipped; the driver falls
back to PIO internally. But none of the DMA-mode configuration is
undone, so the PIO transfer runs with CTRL.SMC set, the wrong burst
length and dynamic_burst cleared, and the transferred data is corrupted.
This is easily hit on i.MX8MP boards that describe ECSPI DMA in the
device tree but run SDMA on ROM firmware (no external sdma-imx7d.bin):
every ECSPI DMA prepare fails. An Infineon SLB9670 TPM on ECSPI1 then
returns shifted TPM2_GetCapability data, is flagged "field failure
mode", /dev/tpmrm0 is never created.
Set controller->fallback before re-running spi_imx_setupxfer() so the
ECSPI is reconfigured exactly like a normal PIO transfer. With
controller->fallback set, spi_imx_setupxfer() sees spi_imx_can_dma()
return false, so it clears spi_imx->usedma and reprograms the controller
(clears CTRL.SMC, restores dynamic_burst and the PIO burst length). No
explicit spi_imx->usedma = false is needed: setupxfer() already updates
it from the can_dma() result. |
| In the Linux kernel, the following vulnerability has been resolved:
fs/resctrl: Fix use-after-free during unmount
During unmount or failure teardown all mon_data structures that contain
monitoring event file private data are freed after which kernfs nodes are
removed. However, the RDT_DELETED flag is never set for the statically
allocated default resource group.
A concurrent reader of an event file associated with the default resource
group may, after dropping kernfs active protection, block on rdtgroup_mutex
while unmount proceeds to free the file private data and destroy the kernfs
node without waiting for the reader.
When the mutex is released, the reader wakes up, observes that RDT_DELETED
is not set for the default group, and dereferences the already-freed
file private data.
The scenario can be depicted as follows:
CPU0 CPU1
/*
* Default resource group's
* monitoring data accessible via
* kernfs file with kernfs_node::priv
* pointing to a struct mon_data.
* User opens the file for reading.
*/
rdtgroup_mondata_show() /* arch encounters fatal error */
rdtgroup_kn_lock_live() resctrl_exit()
atomic_inc(&rdtgroup_default.waitcount) cpus_read_lock()
kernfs_break_active_protection(kn) mutex_lock(&rdtgroup_mutex)
cpus_read_lock() resctrl_fs_teardown()
mutex_lock(&rdtgroup_mutex) rmdir_all_sub()
mon_put_kn_priv()
/* Delete all mon_data structures */
rdtgroup_destroy_root()
kernfs_destroy_root()
rdtgroup_default.kn = NULL
mutex_unlock(&rdtgroup_mutex)
/*
* rdtgroup_default.flags is empty so
* rdtgroup_kn_lock_live() returns
* &rdtgroup_default
*/
md = of->kn->priv;
/* md points to freed mon_data */
Set RDT_DELETED for the default group unconditionally since the flag does
not lead to the freeing of this statically allocated group.
Do not allow a new resctrl mount if there are any waiters on default group
of previous mount. A new mount will re-initialize the default group that
would appear to waiters from previous mount as though the default group is
accessible causing them to access the mon_data structures from the previous
mount that have been removed. |
| rsync before 3.5.0 contains a path traversal vulnerability that allows remote clients to access files outside the intended module root when use chroot is disabled and the module root path or a component of it is a symlink. The daemon calls chdir() to the module root at session initialization without resolving symlinks via realpath() or equivalent, causing subsequent relative-path operations to reference files relative to the symlink target rather than the intended module root, enabling unauthorized file access. |
| IBM Db2 11.5.0 through 11.5.9, and 12.1.0 through 12.1.5 for Linux, UNIX and Windows (includes DB2 Connect Server) could allow a local attacker to obtain sensitive information due to the logging of plain text passwords in trace files. |
| SiYuan versions before v3.7.4 disclose encrypted-notebook key-derivation material and wrapped data keys through unauthenticated endpoints in publish mode. Attackers can retrieve Argon2id salt, cost parameters, password verifiers, and wrapped notebook keys to perform unlimited offline master-password cracking without rate limiting. |
| SiYuan versions before v3.7.4 fail to mask sensitive configuration fields in the /api/system/getConf endpoint, allowing anonymous or publish-reader users to obtain the session-cookie signing key, OS username via pandoc path, and encrypted-notebook key material. Attackers can forge and tamper with session cookies to impersonate users, and on instances without access-auth codes configured, escalate to administrator privileges. |
| The vulnerability, if exploited, could allow an authenticated miscreant
with "DNA Authority - Operator" privilege to tamper with serialized
data, potentially resulting in code execution during deserialization
under the privilege of Enterprise SCADA security group "DNA Apps". |
| filebrowser versions before 2.63.19 contain an out-of-scope file deletion vulnerability in the TUS upload cache eviction mechanism that allows authenticated users with only Create permission to delete arbitrary files outside their scope. Attackers can swap an ancestor directory with a symlink during the cache TTL window to redirect the raw os.Remove call to an out-of-scope target, bypassing ScopedFs scope guards and Perm.Delete checks. |
| rsync before 3.5.0 contains an arbitrary file write vulnerability that allows attackers to write files outside the intended destination tree by specifying an absolute path via --temp-dir or --link-dest options. The rename-confinement logic is bypassed when these options resolve to paths outside the destination tree, enabling attacker-controlled values to write files to arbitrary locations accessible to the rsync process. |
| As part of Cisco's ongoing commitment to proactive security and product quality, the Cisco Catalyst SD-WAN engineering team has conducted a comprehensive internal security review. This review resulted in software hardening releases that address multiple internally discovered vulnerabilities.
The vulnerabilities tracked by CVE-2026-20310 are related to improper link resolution before file access issues that are grouped under the Common Weakness Enumeration (CWE) CWE-59. |
