| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
net: lan743x: Initialize eth_syslock spinlock before use
lan743x_hardware_init() calls pci11x1x_strap_get_status() during the
PCI11x1x probe sequence. That helper acquires the Ethernet subsystem
hardware lock via lan743x_hs_syslock_acquire(), which relies on
adapter->eth_syslock_spinlock to serialize access.
The spinlock is currently initialized only after the strap status is
read. With CONFIG_DEBUG_SPINLOCK enabled, taking the zeroed initialized
spinlock can trip the spinlock debug check.
Fix by initializing adapter->eth_syslock_spinlock before reading the
strap status so the probe path never attempts to lock an uninitialized
spinlock. |
| In the Linux kernel, the following vulnerability has been resolved:
net: ip_vti: require CAP_NET_ADMIN in the device netns for changelink
vti_changelink() operates on at most two netns, dev_net(dev) and the
tunnel link netns t->net. They differ once the device is created in or
moved to a netns other than the one the request runs in. The rtnl
changelink path checks CAP_NET_ADMIN only against dev_net(dev), so a
caller privileged there but not in t->net can rewrite a tunnel that
lives in t->net.
Gate vti_changelink() on rtnl_dev_link_net_capable() at its top,
before any attribute is parsed. |
| In the Linux kernel, the following vulnerability has been resolved:
gpio: mt7621: avoid corruption of shared interrupt trigger state
The bank-shared fields like 'rising' and 'falling' are modified using
non-atomic read-modify-write operations. Since every gpio chip instance
represents an entire bank of 32 pins, if 'mediatek_gpio_irq_type()' is
called concurrently for different IRQs on the same bank a possible overwrite
of each other's configuration is possible. Thus, protect this state with
'gpio_generic_lock_irqsave' lock in the same way it is handled in irp_chip
'mediatek_gpio_irq_mask()' and 'mediatek_gpio_irq_unmask()' callbacks. |
| In the Linux kernel, the following vulnerability has been resolved:
net: mana: Sync page pool RX frags for CPU
MANA allocates RX buffers from page pool fragments when frag_count is
greater than 1. In that case the buffers remain DMA mapped by page pool
and the RX completion path does not call dma_unmap_single(). As a result,
the implicit sync-for-CPU normally performed by dma_unmap_single() is
missing before the packet data is passed to the networking stack.
This breaks RX on configurations which require explicit DMA syncing, for
example when booted with swiotlb=force.
Fix this by recording the page pool page and DMA sync offset when the RX
buffer is allocated, and syncing the received packet range for CPU access
before handing the RX buffer to the stack. |
| In the Linux kernel, the following vulnerability has been resolved:
posix-cpu-timers: Use u64 multiplication in update_rlimit_cpu()
update_rlimit_cpu() converts the RLIMIT_CPU value to nanoseconds with
u64 nsecs = rlim_new * NSEC_PER_SEC;
On 32-bit kernels both rlim_new (unsigned long) and NSEC_PER_SEC
(1000000000L) are 32-bit, so the multiplication is performed in unsigned
long and truncated for rlim_new > 4 seconds before being widened to u64.
The same file already casts to u64 for the matching computation in
check_process_timers():
u64 softns = (u64)soft * NSEC_PER_SEC;
As a result, the truncated value is installed into the CPUCLOCK_PROF
expiry cache (nextevt), causing the process CPU timer to be programmed
to fire prematurely for any RLIMIT_CPU soft limit >= 5 seconds. The
actual SIGXCPU/SIGKILL decision in check_process_timers() already casts
to u64 and is therefore correct, so limit enforcement is not broken;
only the expiry-cache programming is wrong. Apply the same cast here so
both paths convert rlim_cur identically.
64-bit kernels are unaffected. |
| In the Linux kernel, the following vulnerability has been resolved:
bpf: Reject negative const offsets for buffer pointers
The verifier rejects variable offsets for PTR_TO_TP_BUFFER and PTR_TO_BUF
accesses, but it currently accepts a constant negative offset produced by
pointer arithmetic.
Commit 022ac0750883 ("bpf: use reg->var_off instead of reg->off for
pointers") moved constant pointer offsets from reg->off to reg->var_off.
However, __check_buffer_access() continued to check only the instruction
offset. An access with reg->var_off equal to -8 and an instruction offset
of zero therefore passes verification.
For writable raw tracepoints, the access end is also calculated from the
unsigned reg->var_off.value. An eight-byte access starting at -8 wraps
the calculated end to zero, allowing the program to load and attach
without increasing max_tp_access.
After ensuring that reg->var_off is constant, calculate the effective
access start using signed arithmetic and reject it when it is negative.
Use the validated start to calculate the access end for both
PTR_TO_TP_BUFFER and PTR_TO_BUF. |
| In the Linux kernel, the following vulnerability has been resolved:
mmc: sdhci-esdhc-imx: use pm_runtime_resume_and_get() in suspend
Replace pm_runtime_get_sync() with pm_runtime_resume_and_get() to
simplify error handling. pm_runtime_resume_and_get() automatically
drops the usage counter on failure, avoiding the need for a separate
pm_runtime_put_noidle() call. If it fails, the device is unclocked and
accessing hardware registers would cause a kernel panic, so return the
error immediately. |
| In the Linux kernel, the following vulnerability has been resolved:
mmc: sdhci-esdhc-imx: fix esdhc_change_pinstate() to allow default state restore
esdhc_change_pinstate() checks for pins_100mhz and pins_200mhz at the
top of the function and returns -EINVAL if either is not defined. This
prevents the default case from ever being reached, which means devices
with a sleep pinctrl state but without high-speed pin states (100mhz/
200mhz) can never restore their default pin configuration.
Move the IS_ERR checks for pins_100mhz and pins_200mhz into their
respective switch cases. |
| In the Linux kernel, the following vulnerability has been resolved:
mtd: mchp23k256: use SPI match data for chip caps
The driver stores chip capacity information in both the OF match table
and the SPI id table. Probe currently uses of_device_get_match_data(),
so a non-OF SPI modalias match falls back to mchp23k256_caps even when
the SPI id table selected a different part.
Use spi_get_device_match_data() so SPI id-table driver_data is consumed
when OF match data is absent. This keeps the existing default fallback
while avoiding the wrong MTD geometry for id-table-only matches. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: ieee80211: validate MLE common info length
ieee80211_mle_common_size() uses the first common-info octet as the
common information length for all known MLE types. However,
ieee80211_mle_size_ok() only validates that octet for Basic, Probe
Request, and TDLS MLEs.
Reconfiguration MLEs also skipped the length octet when calculating the
minimum common size, and Priority Access MLEs skipped validation of the
advertised common information length.
Account for the Reconfiguration common-info length octet and validate
the advertised common information length for all known MLE types. Keep
unknown-type handling unchanged.
[remove now misleading comment] |
| In the Linux kernel, the following vulnerability has been resolved:
reset: sunxi: fix memory region leak on ioremap failure
In sunxi_reset_init(), when ioremap() fails, the memory region obtained
via request_mem_region() is not released, leading to a resource leak.
Add an err_mem_region label to properly release the memory region before
freeing the data structure. |
| In the Linux kernel, the following vulnerability has been resolved:
ipvs: reload ip header after head reallocation
__ip_vs_get_out_rt() calls skb_ensure_writable() which may
reallocate skb->head. |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: btrtl: validate firmware patch bounds
rtlbt_parse_firmware() copies patch_length - 4 bytes before appending the
firmware version. A malformed firmware patch shorter than the version field
can make this subtraction underflow and turn the copy into an oversized
read and write during Bluetooth setup.
The existing patch_offset + patch_length check can also wrap on 32-bit
architectures. Validate the patch length and range without arithmetic
overflow before allocating or copying the patch. |
| In the Linux kernel, the following vulnerability has been resolved:
pmdomain: mediatek: Fix possible nullptr KP in HWV cleanup/on-check
Should probe fail for HW_VOTER type power domains, this driver was
unconditionally trying to perform cleanup for DIRECT_CTL domains,
but only after checking if the target domain is powered on... with
the DIRECT_CTL scpsys_domain_is_on() code again.
And there's more: the scpsys_domain_is_on() function is also being
unconditionally used in the probe path, for any power domain that
has flag MTK_SCPD_KEEP_DEFAULT_OFF!
This bug was never experienced by anyone because the HWV domains
never failed probe, and because none of those is declared with the
aforementioned flag - but it's still something critical.
In order to fix this, add a check for MTCMOS Type and, based on
that, call the correct functions for an "is on" check, and also
do the same for the cleanup path, calling the correct functions
for the "power off" action.
For the latter, since there's a call to pm_genpd_remove() right
before calling power_off, be cautious and add a variation of the
power off functions (with a _internal suffix) for those to get a
pointer to scpsys_domain instead of one to generic_pm_domain as,
even if that's still working, this is way too much fragile and
would break at some point. |
| In the Linux kernel, the following vulnerability has been resolved:
pmdomain: imx93-blk-ctrl: Extract PHY as shared domain for DSI/CSI
The MIPI DSI and CSI domains share control bits for clock and reset, which
can lead to incorrect behavior if one domain disables the shared resource
while the other is still active.
To fix the issue, introduce a shared MIPI PHY power domain to own the
common resources and make DSI and CSI its subdomains. This ensures the
shared bits are properly managed and not disabled while still in use. |
| In the Linux kernel, the following vulnerability has been resolved:
cgroup/cpuset: rebind mm mempolicy to effective_mems, not mems_allowed
Creating a child cpuset where cpuset.mems is never set leads to a div/0
when a VMA mempolicy with MPOL_F_RELATIVE_NODES rebinds in response to a
CPU hotplug event.
Reproduction steps:
1) Create a cgroup w/ cpuset controls (do not set cpuset.mems)
2) Move the task into the child cpuset
3) Create a VMA mempolicy for that task with MPOL_F_RELATIVE_NODES
4) unplug and hotplug a cpu
echo 0 > /sys/devices/system/cpu/cpu1/online
echo 1 > /sys/devices/system/cpu/cpu1/online
5) mempolicy rebind does a div/0 in mpol_relative_nodemask on the
call to __nodes_fold()
The cpuset code passes (cs->mems_allowed) which is not guaranteed to have
nodes to the rebind routine. Use cs->effective_mems instead, which is
guaranteed to have a non-empty nodemask once we reach that code path.
[ david: add a comment, slightly rephrase description ] |
| In the Linux kernel, the following vulnerability has been resolved:
s390/diag: Add missing array_index_nospec() call to memtop_get_page_count()
'level' is user space controlled and used to read from an array. Add the
missing array_index_nospec() call to prevent speculative execution. |
| In the Linux kernel, the following vulnerability has been resolved:
riscv: Prevent NULL pointer dereference in machine_kexec_prepare()
A NULL pointer dereference issue is noticed in riscv's
machine_kexec_prepare(), where image->segment[i].buf might be NULL and
copied unchecked.
The NULL buf comes from ima_add_kexec_buffer(), where kbuf is added by
kexec_add_buffer(), but kbuf.buffer is NULL, then it is copied without
a check in machine_kexec_prepare():
kexec_file_load
-> kimage_file_alloc_init()
-> kimage_file_prepare_segments()
-> ima_add_kexec_buffer()
-> kexec_add_buffer()
-> machine_kexec_prepare()
-> memcpy()
Address this by adding a check before the data copy attempt. |
| In the Linux kernel, the following vulnerability has been resolved:
Input: ims-pcu - fix use-after-free and double-free in disconnect
ims_pcu_disconnect() only intended to perform cleanup when the primary
(control) interface is unbound. However, it currently relies on the
interface class to distinguish between control and data interfaces.
A malicious device could present a data interface with the same class
as the control interface, leading to premature cleanup and potential
use-after-free or double-free.
Switch to verifying that the interface being disconnected is indeed
the control interface. |
| In the Linux kernel, the following vulnerability has been resolved:
scsi: elx: efct: Fix refcount leak in efct_hw_io_abort()
When efct_hw_reqtag_alloc() fails in efct_hw_io_abort(), the error path
returns -ENOSPC without releasing the reference obtained via
kref_get_unless_zero() earlier in the function. All other error paths
correctly drop the reference. This causes a permanent reference leak on the
io_to_abort object.
Additionally, the abort_in_progress flag is left set to true on this path,
which means future abort attempts for the same I/O will immediately return
-EINPROGRESS even though the abort was never submitted, effectively
blocking recovery.
Fix this by adding the missing kref_put() call and reset abort_in_progress
to false, matching the cleanup done in the efct_hw_wq_write() failure path
below. |
