| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
rtase: fix double free of multi-frag skb on DMA map failure
In rtase_start_xmit(), when the head buffer DMA mapping fails after
rtase_xmit_frags() has mapped all fragments, the error path clears
the fragment descriptors with rtase_tx_clear_range(), which frees
the skb through the last-frag slot and accounts tx_dropped. Control
then falls through to the common error label, which frees the same
skb a second time and counts it again.
Return right after clearing the fragments when the skb owns frags;
the no-frag case still drops through and frees the head skb once. |
| In the Linux kernel, the following vulnerability has been resolved:
net/sched: cls_u32: validate offshift to prevent shift-out-of-bounds
u32_change() copies the user-provided tc_u32_sel.offshift (unsigned char,
0-255) into the kernel knode object without bounds validation. When a
packet later hits u32_classify() with TC_U32_VAROFFSET set, it evaluates
`ntohs(offmask & *data) >> offshift` where the left operand is a 16-bit
value promoted to a 32-bit int. Any offshift >= 32 is undefined behavior
per C11 6.5.7p3, triggerable by an unprivileged user via user/network
namespaces.
UBSAN: shift-out-of-bounds in net/sched/cls_u32.c:236:43
shift exponent 32 is too large for 32-bit type int
Fix this by rejecting offshift >= 16 during filter creation in
u32_change(). |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: ISO: clear iso_data always when detaching conn from hcon
When setting conn->hcon = NULL, also conn->hcon->iso_data = NULL is
necessary, otherwise later iso_conn_free() will UAF.
Fix clearing of iso_data in iso_sock_disconn()
Fixes KASAN: slab-use-after-free in iso_conn_hold_unless_zero on
iso_sock_release() followed by hci_abort_conn_sync(). |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: L2CAP: fix UAF in l2cap_le_connect_rsp
l2cap_le_connect_rsp() obtains a channel via
__l2cap_get_chan_by_ident() but neither holds a reference nor uses
l2cap_chan_hold_unless_zero() before locking and operating on it.
A concurrent l2cap_chan_del() triggered by a remote disconnect can
free the channel between the lookup and l2cap_chan_lock(), causing
a use-after-free.
The BR/EDR counterpart l2cap_connect_rsp() and the sibling handler
l2cap_le_command_rej() already use l2cap_chan_hold_unless_zero()
to safely hold a reference, but l2cap_le_connect_rsp() was left
unprotected.
Fix by adding l2cap_chan_hold_unless_zero() after the ident lookup
and l2cap_chan_put() on the exit path, consistent with other L2CAP
response handlers. |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: ISO: lock sk in iso_sock_getname
Accessing iso_pi(sk)->conn requires lock_sock, which is not held here.
Fix by adding the lock/release. |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: ISO: lock sk in iso_connect_ind
Accessing iso_pi(sk)->conn requires lock_sock, which is not taken in the
"ev3" part of iso_connect_ind. It may also be NULL if socket has
transitioned away from the LISTEN/CONNECT states before locking.
Fix by adding lock/release. Recheck hcon is valid after lock acquire
where needed. |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: ISO: hold sk properly in iso_conn_ready
sk deref in iso_conn_ready must be done either under conn->lock, or
holding a refcount, to avoid concurrent close. conn->sk is currently
accessed without either:
[Task 1] [Task 2]
iso_sock_release
iso_conn_ready
sk = conn->sk
lock_sock(sk)
conn->sk = NULL
lock_sock(sk)
release_sock(sk)
iso_sock_kill(sk)
UAF on sk deref
Fix possible UAF by holding sk refcount in iso_conn_ready(). Also
recheck after lock_sock that the socket is still valid. Adjust locking
so conn->sk is cleared only under lock_sock. |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: ISO: avoid deadlocks in iso_sock_timeout
iso_sock_timeout() takes lock_sock, so sync disabling the timer while
holding that lock may deadlock.
iso_sock_timeout() may also run concurrently with iso_conn_del(), which
leads to UAF
[Task 1] [Task hdev->workqueue]
iso_sock_timeout iso_conn_del
iso_conn_hold_unless_zero iso_chan_del
`------------> iso_conn_put
caller frees hcon
iso_conn_put
iso_conn_free
conn->hcon->iso_data = NULL; /* UAF */
Fix the deadlock by removing the disable from the lock_sock sections.
Move the timer from iso_conn to iso_pinfo to decouple it from iso_conn
which may need to be freed in lock_sock section. Convert some of the
clear_timer to disable_timer. |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: ISO: fix refcounting of iso_conn
iso_conn_del() and iso_chan_del() have a race that results to double-put
of iso_conn:
[Task hdev->workqueue] [Task 2]
iso_conn_del iso_chan_del
iso_conn_hold_unless_zero iso_conn_lock
iso_conn_lock conn->sk = NULL
iso_conn_unlock
sk = iso_sock_hold(conn) <---------´
if (!sk) iso_conn_put iso_conn_put
iso_conn_put /* UAF */
The extra put for !sk in iso_conn_del() is currently required since
failing iso_chan_add() may leave iso_conn not associated with any sk.
Fix by having iso_pi(sk)->conn own refcount when non-NULL, so
iso_conn_del does not need to put it. Adjust the iso_conn_add()
refcounting so that conn is put if it does not get associated with an
sk. |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: ISO: fix race of kfree vs kref_get_unless_zero
hci_conn::iso_data is accessed and modified without lock or RCU.
This leads to a race
[Task hdev->workqueue] [Task 2]
iso_recv iso_conn_put(conn)
conn = LOAD hcon->iso_data iso_conn_free(conn)
iso_conn_hold_unless_zero(conn) hcon->iso_data = NULL
kfree(conn)
kref_get_unless_zero(&conn->ref) /* UAF */
and also to races in iso_conn_add() vs. iso_conn_free().
Fix by adding spinlock hci_conn::proto_lock and using it to guard
hci_conn::iso_data. |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: hci_conn: hold conn reference in abort_conn_sync()
There is theoretical UAF if the conn is freed while the hci_sync task is
running.
Hold refcount to avoid that. |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: hci_sync: hold conn in hci_connect_big_sync() callback
There is theoretical UAF if the conn is freed while the hci_sync task is
running.
Hold refcount to avoid that. Handle NULL hcon, return 0 + do nothing to
match the previous behavior. |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: hci_sync: hold conn in hci_connect_pa_sync() callback
There is theoretical UAF if the conn is freed while the hci_sync task is
running.
Hold refcount to avoid that. |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: hci_sync: hold conn in hci_past_sync() callback
Avoids giving freed pointers to hci_conn_valid(), which kmalloc may have
reused.
Hold refcount to avoid that. |
| In the Linux kernel, the following vulnerability has been resolved:
octeontx2-af: Block VFs from clobbering special CGX PKIND state
PF and VF NIX LFs that share a CGX LMAC reuse the same hardware PKIND
programming. When HiGig2 or EDSA parsing is enabled, a VF NIX LF alloc must
not reset the LMAC RX PKIND or default TX parse config over the PF setup.
Add cgx_get_pkind() and rvu_cgx_is_pkind_config_permitted() so VFs skip
cgx_set_pkind(), rvu_npc_set_pkind(), and NIX_AF_LFX_TX_PARSE_CFG updates
when the LMAC is using NPC_RX_HIGIG_PKIND or NPC_RX_EDSA_PKIND. |
| In the Linux kernel, the following vulnerability has been resolved:
qede: sync udp_tunnel ports outside qede_lock in the recovery path
A TX timeout on a qede NIC that has VXLAN/GENEVE tunnel ports
configured wedges the rtnetlink control plane of the whole machine:
NETDEV WATCHDOG: ens6f1 (qede): transmit queue 2 timed out 10226 ms
[qede_tx_timeout:586(ens6f1)]TX timeout on queue 2!
[qede_recovery_handler:2665(ens6f0)]Starting a recovery process
The recovery path deadlocks on the driver's own mutex:
qede_sp_task
rtnl_lock()
mutex_lock(&edev->qede_lock) <- taken
qede_recovery_handler
qede_load
udp_tunnel_nic_reset_ntf
__udp_tunnel_nic_device_sync
info->sync_table == qede_udp_tunnel_sync
mutex_lock(&edev->qede_lock) <- same task: deadlock
The mutex is not recursive, so the kworker blocks on itself with
rtnl_lock held, and neither lock is ever released. Every task that
calls rtnl_lock() afterwards (ip, ovs-vswitchd, lldpad, IPv6
addrconf, sshd) blocks forever while the node still answers ping.
In a vmcore from an affected production node rtnl_mutex.owner
decodes to the very kworker blocked at the innermost mutex_lock()
above.
Re-sync the tunnel ports from qede_sp_task() after the internal lock
is dropped, still under rtnl_lock as the udp_tunnel API requires.
This mirrors qede_open(), which calls udp_tunnel_nic_reset_ntf()
under rtnl without the internal lock.
qede_recovery_handler() now returns whether it has successfully
reloaded an open device, and the caller re-syncs the ports only in
that case. This keeps the old gating exactly: a device that was down
or a failed recovery returns false, as those paths never reached the
udp_tunnel_nic_reset_ntf() call before either.
This was the only user of the qede_lock()/qede_unlock() helpers, so
remove them. |
| In the Linux kernel, the following vulnerability has been resolved:
ksmbd: fix use-after-free in __close_file_table_ids()
A ksmbd_file can remain alive after logical close while another session
holds a temporary reference obtained through ksmbd_lookup_fd_inode().
ksmbd_close_fd() currently marks the file closed and drops the idr-owned
reference, but leaves the pointer published in the closing session's idr
until the final reference is dropped.
If the foreign holder performs the final ksmbd_fd_put(), __put_fd_final()
supplies the foreign session's file table to __ksmbd_close_fd(). The object
is then freed without being removed from its owner's idr, and the owner
session later dereferences the stale pointer during file-table teardown.
Remove the volatile id from the owner's idr while ksmbd_close_fd() still
holds that table's lock, and clear volatile_id before dropping
the idr-owned reference. A later foreign final put then only performs
physical destruction and cannot remove the object from the wrong table. |
| In the Linux kernel, the following vulnerability has been resolved:
ksmbd: use memcmp() to compare ClientGUIDs
ClientGUID is a fixed-size binary value and can contain embedded NUL
bytes. strncmp() stops comparing at the first NUL byte, so different
ClientGUID values can incorrectly be treated as equal.
Use memcmp() in SMB3 multichannel session binding and
FSCTL_VALIDATE_NEGOTIATE_INFO to compare all SMB2_CLIENT_GUID_SIZE
bytes. |
| In the Linux kernel, the following vulnerability has been resolved:
iommu/iommufd: Fix IOPF group ownership UAF
iopf_group_alloc() links each last-page IOPF group into the generic IOPF
pending list before invoking the domain fault handler.
iommufd_fault_iopf_handler() also queued an accepted group in the
IOMMUFD deliver list without removing it from the generic pending list.
When detach or HWPT replacement drops the device's IOPF reference count
to zero, an IOMMU driver may call iopf_queue_remove_device(). That
function responds to and frees groups through the generic pending list
without removing the same groups from IOMMUFD's deliver list or response
xarray. A later read, response, or cleanup can then access the freed
group and cause a UAF.
Fix this by dequeuing an accepted group from the generic pending list
before IOMMUFD queues it for userspace response.
Make iopf_group_response() send a response regardless of pending-list
membership, so the dequeued group can still be completed by IOMMUFD. |
| In the Linux kernel, the following vulnerability has been resolved:
pinctrl: devicetree: don't free uninitialized dev_name on error path
dt_remember_or_free_map() duplicates dev_name for each map entry. If
kstrdup_const() fails, dt_free_map() frees dev_name in all num_maps
entries, including entries that have not been initialized.
Some pinctrl drivers, including pinctrl-imx, allocate the map with
kmalloc() and leave dev_name for the core to initialize. The untouched
entries therefore contain uninitialized data which is passed to
kfree_const().
Reproduced on qemu's mcimx6ul-evk (pinctrl-imx) with failslab injection
while binding the pinctrl-consuming device, under KASAN:
BUG: KASAN: double-free in dt_free_map+0x34/0xa4
Free of addr c425a900 by task init/1
kfree from dt_free_map+0x34/0xa4
dt_free_map from dt_remember_or_free_map+0x184/0x198
dt_remember_or_free_map from pinctrl_dt_to_map+0x33c/0x4c8
pinctrl_dt_to_map from create_pinctrl+0x9c/0x5c0
Initialize all dev_name fields to NULL before duplicating the device
name, making the full-map cleanup safe after a partial failure. |
