| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| The Microchip SERCOM-G1 UART driver (drivers/serial/uart_mchp_sercom_g1.c), used by the PIC32CM-JH SoC family, contains an out-of-bounds write in its asynchronous (DMA) receive path. When uart_rx_enable() is invoked with a one-byte receive buffer (len == 1) and CONFIG_UART_MCHP_ASYNC is enabled, the RX-complete ISR starts a single-beat DMA transfer while a received byte is already pending in the SERCOM DATA register. On this SoC the peripheral-triggered DMA start sequencing then writes one byte past the end of the caller-supplied buffer (CWE-787).
The overflowed byte's value is the UART RX data supplied by the connected serial peer (adjacent attacker), while its size and location are fixed at one byte immediately after the buffer.
Exploitation requires the async UART config (not enabled by default on the in-tree PIC32CM-JH boards) and a consumer that enables RX with a one-byte buffer; impact is limited single-byte memory corruption adjacent to the RX buffer (possible crash / denial of service).
The defect shipped in v4.4.0. The fix reads the first byte with the CPU and, for one-byte buffers, performs no DMA at all; for larger buffers it sizes the DMA for the remaining len-1 bytes. |
| Zephyr's IP socket recvmsg() implementation (subsys/net/lib/sockets/sockets_inet.c, insert_pktinfo()) validated the user-supplied ancillary (msg_control) buffer using only the payload length (msg->msg_controllen < pktinfo_len) before writing a full control message consisting of an aligned cmsg header plus the payload. Because the check omitted the cmsg header size, a control buffer whose length falls in the under-checked window (e.g. 16-27 bytes for IPv4 IP_PKTINFO on a 64-bit target, where a single element actually occupies 28 bytes) passes the guard yet causes a fixed-size out-of-bounds write of up to one cmsg header (~12 bytes) past the end of the buffer.
Under CONFIG_USERSPACE the recvmsg verifier allocates a kernel-heap copy of the control buffer sized to msg_controllen and runs the implementation against it, so the overflow corrupts kernel heap memory and is triggerable from an unprivileged userspace thread; in supervisor mode it corrupts the caller's buffer.
The path is reachable on a UDP/IP socket with IP_PKTINFO/IPV6_RECVPKTINFO (or hoplimit/timestamping) enabled when the application calls recvmsg() with an undersized control buffer and a datagram is received; part of the overwritten bytes (the destination IP in ipi_addr) is influenced by the received packet.
The fix makes the capacity check use NET_CMSG_SPACE(pktinfo_len) (aligned header + aligned data) and returns -ENOMEM when the buffer is too small. Affected: v3.6.0 through v4.4.0. |
| Zephyr's Bluetooth Classic Hands-Free Profile (HFP) Hands-Free role parser (subsys/bluetooth/host/classic/hfp_hf.c) contains an out-of-bounds write. During Service Level Connection setup the HF sends AT+CIND=? and parses the AG's +CIND: response in cind_handle(), which assigns a per-entry counter index and calls cind_handle_values() for each list element. cind_handle_values() then wrote hf->ind_table[index] = i without verifying that index is within the 20-element int8_t ind_table[] array of struct bt_hfp_hf. Because the parser places no cap on the number of +CIND: list entries, a remote Attendant Gateway (a malicious, compromised, or spoofed peer the device connects to over Bluetooth) can send a response with more than 20 recognized indicator entries and drive index arbitrarily large, writing a small attacker-positioned value past the array into adjacent struct fields (feature masks, SDP/version state, the calls[] array, work/atomic bookkeeping) and potentially beyond the static connection pool slot. This yields memory corruption and at least denial of service of the Bluetooth host, triggered by a single malformed AT response with no user interaction. The sibling consumer ag_indicator_handle_values() already performed the equivalent bounds check; this commit adds the same index >= ARRAY_SIZE(hf->ind_table) guard to close the gap. Affects builds with CONFIG_BT_HFP_HF enabled; introduced with the original HFP HF CIND parser (~v1.7) and present through v4.4.0. |
| Improper neutralization of special elements used in a command ('command injection') in Visual Studio Code allows an unauthorized attacker to execute code locally. |
| Improper neutralization of special elements used in a command ('command injection') in Windows Admin Center allows an authorized attacker to execute code over a network. |
| Allocation of resources without limits or throttling in HTTP/2 allows an unauthorized attacker to deny service over a network. |
| Memory allocation with excessive size value in Windows Local Security Authority Subsystem Service (LSASS) allows an unauthorized attacker to deny service over a network. |
| Pillow is a Python imaging library. Prior to 12.3.0, Pillow's ImageCms.ImageCmsTransform.apply(im, imOut) API can trigger controlled native heap corruption when the caller supplies an output image whose mode does not match the transform's declared output mode. This issue is fixed in version 12.3.0. |
| Easy!Appointments is a self hosted appointment scheduler. Versions prior to 1.6.0 allow administrators to define a custom "booking disabled" message through the booking settings page. That value is stored in the `disable_booking_message` setting via a rich-text editor and later passed directly to the public `booking_message` view without escaping or sanitization. An authenticated administrator can store HTML or JavaScript in this field, enable disabled-booking mode, and trigger stored XSS in every unauthenticated visitor who opens the public booking page. Version 1.6.0 fixes the issue. |
| Summary
Cloudflare quiche was discovered to be vulnerable to memory resource exhaustion due to unbounded queuing of post-handshake client migration events.
Impact
quiche supports the connection migration features described in Section 9 of RFC 9000, which allows a single QUIC connection to survive changes in the network path. Although quiche implements the protections described in Section 9.3 of RFC 9000 to limit server state commitment, it was discovered that the collection of PathEvents, intended to be consumed by applications via the path_event_next() function, was not bounded.
Once the QUIC handshake completed, a peer could exploit rapid source address migration in order to cause unbounded queuing of the PathEvent::ReusedSourceConnectionId type. Servers are vulnerable even if active connection migration is disabled.
Mitigation:
*
Applications can call path_event_next() to drain the PathEvent collection, mitigating the attack.
*
Users are requested to upgrade to quiche 0.29.3 which is the earliest version that prevents excessive queueing of PathEvent::ReusedSourceConnectionId. |
| On Xtensa SoCs built with CONFIG_XTENSA_MPU and CONFIG_USERSPACE, arch_buffer_validate() in arch/xtensa/core/mpu.c — the architecture hook that verifies a user-mode-supplied buffer is accessible to the calling user thread with the requested permission — defaulted its return value to 0 (access permitted) and only set a denial result inside its per-MPU-region probe loop. When the rounded extent of the buffer wraps the 32-bit address space (size + alignment offset near SIZE_MAX, or ROUND_UP(size + offset) overflowing to 0), the loop executes zero iterations and the function returns 0 = permitted without probing any MPU region.
The syscall-layer pre-checks (K_SYSCALL_MEMORY_SIZE_CHECK / Z_DETECT_POINTER_OVERFLOW) only catch a raw addr+size wrap and do not cover the ROUND_UP-induced wrap, and the string path (arch_user_string_nlen -> arch_buffer_validate) has no syscall-layer guard at all.
An unprivileged user-mode thread can therefore pass a crafted (addr, size) to any syscall that validates user buffers via k_usermode_from_copy/to_copy or k_usermode_string_copy and have validation succeed for memory it must not access; the kernel then reads from (disclosure) or, with write=1, writes to (corruption) attacker-chosen kernel or other-partition memory on the thread's behalf, enabling information disclosure, memory corruption, privilege escalation, and denial of service.
Affected from v3.7.0 (when Xtensa MPU userspace support was added) through v4.4.0. The fix changes the default to -EINVAL (deny by default), adds an explicit size_add_overflow check, and sets the success value only after the full range has been validated. |
| Improper Neutralization of Special Elements used in an OS Command ('OS Command Injection') vulnerability in Apache Kylin. A backend API may bring job config parameters to OS command line.
This issue affects Apache Kylin: from 4 through 5.0.3.
Users are recommended to upgrade to version 5.0.4, which fixes the issue. |
| OpenClinic GA 5.351.19 contains a reflected cross-site scripting vulnerability in the DICOM image upload handler that allows attackers to execute arbitrary JavaScript in a victim's browser by embedding malicious payloads in DICOM file metadata fields. Attackers can craft a DICOM file with JavaScript payloads in metadata fields such as Study Description, which are reflected without sanitization in popup.jsp and archiving/uploadfiles_jsp.java when processed through the Upload DICOM images feature. |
| QloApps through 1.7.0 contains a stored cross-site scripting vulnerability in the admin file manager that allows authenticated administrators to inject malicious JavaScript by uploading crafted SVG files. Attackers can embed JavaScript event handlers such as onload within SVG files uploaded through the file manager to execute arbitrary scripts in the browser of any user who subsequently views the file. |
| A Stored Cross-Site Scripting security issue exists within FactoryTalk® DataMosaix™ Private Cloud. The vulnerability stems from improper neutralization of user-supplied input within the Workflows configuration. An authenticated attacker with high privileges can inject malicious scripts that are permanently stored on the server. This vulnerability can result in the execution of malicious JavaScript when other users access the affected page, potentially allowing for account takeover, credential theft, or redirection to a malicious website. |
| Cockpit CMS through version 2.14.0, patched in commit 72a83fc, contains a stored cross-site scripting vulnerability in the Set field type's Display template option, where the template string is processed by the $interpolate function using new Function() and rendered via Vue's v-html directive without sanitization. An attacker with content/:models/manage permission can inject arbitrary JavaScript into the Display template, which executes in the browser of any user viewing the collection items list. |
| Hashgraph Guardian through 3.6.0, fixed in commit ba8c566, contains a stored cross-site scripting vulnerability that allows authenticated users with the STANDARD_REGISTRY role to inject malicious scripts by submitting a crafted companyName value via the branding configuration API endpoint. Attackers can exploit the unsanitized innerHTML assignment in the branding service to execute arbitrary JavaScript in the browser of every authenticated user on every page load. |
| Versions of the package validator before 13.15.22 are vulnerable to Incomplete Filtering of One or More Instances of Special Elements in the isLength() function that does not take into account Unicode variation selectors (\uFE0F, \uFE0E) appearing in a sequence which lead to improper string length calculation. This can lead to an application using isLength for input validation accepting strings significantly longer than intended, resulting in issues like data truncation in databases, buffer overflows in other system components, or denial-of-service. |
| A denial-of-service security issue exists in the 1719-AENTR. The security issue stems from improper handling of a UDP unicast network storm, which causes the device to become overloaded and lose communication. A power cycle is required to recover. |
| A vulnerability was determined in Comfast CF-WR631AX V3 up to 2.7.0.8. Affected by this vulnerability is the function system_wl_upload_pic_file of the file /usr/bin/webmgnt of the component FastCGI Backend. This manipulation of the argument filename causes os command injection. It is possible to initiate the attack remotely. The exploit has been publicly disclosed and may be utilized. The vendor was contacted early about this disclosure but did not respond in any way. |
