| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| GitLab has remediated an issue in GitLab CE/EE affecting all versions from 18.2 before 19.0.6, 19.1 before 19.1.4, and 19.2 before 19.2.2 that under certain conditions could have allowed cross-site scripting due to improper neutralization of user-controlled values rendered in table cell content by an analytics dashboard component. |
| IBM i 7.6, 7.5, 7.4, and 7.3 could allow a remote attacker to cause a denial of service due to a buffer overflow. |
| In the Linux kernel, the following vulnerability has been resolved:
ALSA: usb-audio: fix OOB write in snd_usbmidi_akai_output()
snd_usbmidi_akai_output() computes its fill-loop bound
buf_end = ep->max_transfer - MAX_AKAI_SYSEX_LEN - 1;
as a signed int, so a small device-advertised bulk-OUT max_transfer
makes buf_end negative. The loop guard then compares the u32
urb->transfer_buffer_length against that negative int: the usual
arithmetic conversion turns buf_end into a large unsigned value, so the
guard stays true and each iteration keeps appending SysEx framing and
payload bytes past the end of the URB transfer buffer, which is only
max_transfer bytes long.
A USB device that advertises a tiny bulk-OUT endpoint can therefore
trigger an attacker-length- and content-controlled heap out-of-bounds
write when a process writes to the created /dev/snd/midiC*D* node.
Return early when there is no room for even one SysEx, so the loop is
never entered with a bound that would wrap. The loop is the last
statement of the function, so bailing out is equivalent to it not
running.
Discovered by XBOW, triaged by Baul Lee <baul.lee@xbow.com> |
| In the Linux kernel, the following vulnerability has been resolved:
net: openvswitch: fix skb leak on flow key update failure during ct
ovs_ct_execute() always steals or frees the skb on failure while
ovs_flow_key_update() does not. So, if it fails and we return right
away, the skb ends up leaked.
Fix that by breaking instead and letting the common error handling
code at the bottom of the loop to free the skb properly.
This is a very unlikely scenario as it requires the packet to become
unparseable by applying a set of actions on a previously parseable skb,
but should be fixed nevertheless.
Reported by Sashiko. |
| IBM i 7.6, 7.5, 7.4, and 7.3 could allow a remote attacker to cause a denial of service due to an improper buffer write. |
| In the Linux kernel, the following vulnerability has been resolved:
mips: sched: Fix CPUMASK_OFFSTACK memory corruption
This patch addresses a critical memory management flaw. When
CONFIG_CPUMASK_OFFSTACK is enabled, cpumask_var_t is a pointer.
Consequently, sizeof(new_mask) evaluates to the pointer size, causing
copy_from_user() to clobber the mask pointer. Furthermore, the old
logic performed copy_from_user() before allocating the mask.
Fix this by allocating new_mask first. To handle variable-sized user
masks correctly, use cpumask_size() to truncate overly large user masks
or pad undersized masks with zeros before copying the data directly into
the allocated buffer. |
| IBM i 7.6, 7.5, 7.4, and 7.3 could allow a local attacker to execute arbitrary code or cause a denial of service due to improper bounds checking. |
| In the Linux kernel, the following vulnerability has been resolved:
can: bcm: fix stale rx/tx ops after device removal
RX: an RX_SETUP update(!) for an existing op skipped can_rx_register()
unconditionally, even when a concurrent NETDEV_UNREGISTER had already
torn down its registration (op->rx_reg_dev == NULL). This silently
did not re-enable frame delivery for that updated filter. bcm_rx_setup()
now re-registers in that case, while leaving rx_ops with ifindex = 0
(all CAN devices) which never carry a tracked rx_reg_dev registered as-is.
TX: bcm_notify() only handled bo->rx_ops on NETDEV_UNREGISTER, leaving
tx_ops with an active cyclic transmission re-arming its hrtimer
indefinitely to execute bcm_tx_timeout_handler(). Cancelling the hrtimer
prevents the runaway timer and any injection into a later reused ifindex,
since nothing else calls bcm_can_tx() for the op until an explicit
TX_SETUP update re-arms it.
Unlike bcm_rx_unreg(), which clears the tracked rx_reg_dev for rx_ops,
the ifindex is intentionally left unchanged for tx_ops. bcm_tx_setup()
always rejects ifindex 0, so clearing it would strand the op: neither a
later TX_SETUP (bcm_find_op()) nor TX_DELETE (bcm_delete_tx_op()) could
ever find it again, since both require an exact ifindex match. |
| IBM i 7.6, 7.5, 7.4, and 7.3 could allow a remote attacker to cause a denial of service due to a stack-based buffer overflow. |
| In the Linux kernel, the following vulnerability has been resolved:
btrfs: free mapping node on duplicate reloc root insert
__add_reloc_root() allocates a mapping_node before inserting it into
rc->reloc_root_tree. If rb_simple_insert() finds an existing entry, it
returns the existing rb_node and leaves the newly allocated node unlinked.
The error path then returns -EEXIST without freeing the new node. Since
the node was never inserted into reloc_root_tree, the later cleanup in
put_reloc_control() cannot find it either.
Free the newly allocated node before returning -EEXIST.
The callers currently assert that -EEXIST should not happen, so this is a
defensive cleanup for an unexpected duplicate insert path. If the path is
ever reached, the local allocation should still be released. |
| IBM i 7.6, 7.5, 7.4, and 7.3 could allow a remote attacker to cause a denial of service due to an out-of-bounds write. |
| In the Linux kernel, the following vulnerability has been resolved:
btrfs: fix root leak if its reloc root is unexpected in merge_reloc_roots()
If we have an unexpected reloc_root for our root, we jump to the out label
but never drop the reference we obtained for root, resulting in a leak.
Add a missing btrfs_put_root() call. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: ipw2100: fix potential memory leak in ipw2100_pci_init_one()
The memory allocated in the ipw2100_alloc_device() function is not freed
in some of the error paths in ipw2100_pci_init_one(). Fix that by
converting the direct return into a goto to the error path return.
The error path when pci_enable_device() fails cannot jump to fail, since
at this point priv is not set, so perform error handling inline. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211_hwsim: clamp virtio RX length before skb_put
hwsim_virtio_rx_work() passes the virtqueue used-ring length reported by
the device straight to skb_put() on a fixed-size receive skb. A backend
reporting a length larger than the skb tailroom drives skb_put() past the
buffer end and hits skb_over_panic() -- a host-triggerable guest panic
(denial of service).
Clamp the length to the skb's available room before skb_put(). A
conforming device never reports more than the posted buffer size, so valid
frames are unaffected; a truncated over-report then fails the
length/header checks in hwsim_virtio_handle_cmd() and is dropped, so
truncating rather than dropping here cannot be turned into a parsing
problem. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: libertas: fix memory leak in helper_firmware_cb()
helper_firmware_cb() neglects to free the single-stage firmware image
after a successful async load, leading to a memory leak in the USB
firmware-download path.
Fix this memory leak by calling release_firmware() immediately after
lbs_fw_loaded() returns.
The bug was first flagged by an experimental analysis tool we are
developing for kernel memory-management bugs while analyzing
v6.13-rc1. The tool is still under development and is not yet publicly
available. Manual inspection confirms that the bug is still present in
the current wireless tree.
An x86_64 allyesconfig build showed no new warnings. As we do not have
compatible Libertas USB hardware for exercising this firmware-download
path, no runtime testing was able to be performed. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: nl80211: free RNR data on MBSSID mismatch
nl80211_parse_beacon() rejects EMA RNR data when there are fewer RNR
entries than MBSSID entries.
The rejected RNR allocation has not been attached to the beacon data yet,
so free it before returning the error. |
| In the Linux kernel, the following vulnerability has been resolved:
sctp: fix auth_hmacs array size in struct sctp_cookie
The auth_hmacs array in struct sctp_cookie is supposed to store a complete
SCTP_AUTH_HMAC_ALGO parameter, which consists of a struct sctp_paramhdr
followed by N HMAC identifiers.
However, the array size was calculated using an extra 2 bytes instead of
sizeof(struct sctp_paramhdr), which is 4 bytes. When four HMAC identifiers
are configured, the HMAC-ALGO parameter stored in the endpoint is larger
than the auth_hmacs buffer in the cookie.
As a result, sctp_association_init() copies beyond the end of auth_hmacs
when initializing the association, corrupting the adjacent auth_chunks
field. This can lead to an invalid HMAC identifier being accepted and later
cause an out-of-bounds read in sctp_auth_get_hmac().
Fix the array size calculation by including the full SCTP parameter header
size. |
| In the Linux kernel, the following vulnerability has been resolved:
USB: serial: io_edgeport: cap received transmit credits
The interrupt-status packet reports transmit credits returned by the
device. edge_interrupt_callback() adds the 16-bit value to txCredits
without checking maxTxCredits.
edge_write() uses txCredits minus the software FIFO count as the amount
of data that fits. Since the FIFO is allocated with maxTxCredits bytes,
txCredits exceeding maxTxCredits can cause OOB write in ring buffer.
Cap accumulated credits at maxTxCredits. Conforming devices should never
hit the cap. |
| In the Linux kernel, the following vulnerability has been resolved:
hwmon: (corsair-psu) Stop device IO before calling hid_hw_stop
hid_hw_stop() does not stop the device IO.
This results in a race condition between hid_input_report() and the point
immediately following the execution of hid_device_io_start() within
corsairpsu_probe(). If the probe operation fails after "io start" has
been initiated, this race condition will result in a uaf vulnerability
[1].
CPU0 CPU1
==== ====
corsairpsu_probe()
hid_device_io_start()
... unlock driver_input_lock
hid_hw_stop()
kfree(hidraw) __hid_input_report()
... acquire driver_input_lock
hid_report_raw_event()
hidraw_report_event()
... access hidraw's list_lock // trigger uaf
Consequently, when corsairpsu_probe() fails and hid_hw_stop() needs to
be executed, the io_started flag is first cleared while holding the
driver_input_lock to prevent potential race conditions involving input
reports.
[1]
BUG: KASAN: slab-use-after-free in rt_spin_lock+0x83/0x400 kernel/locking/spinlock_rt.c:56
Call Trace:
hidraw_report_event+0x5d/0x3a0 drivers/hid/hidraw.c:577
hid_report_raw_event+0x311/0x1730 drivers/hid/hid-core.c:2076
__hid_input_report drivers/hid/hid-core.c:2152 [inline]
hid_input_report+0x44e/0x580 drivers/hid/hid-core.c:2174
hid_irq_in+0x47e/0x6d0 drivers/hid/usbhid/hid-core.c:286
__usb_hcd_giveback_urb+0x3b3/0x5e0 drivers/usb/core/hcd.c:1657
dummy_timer+0x8a9/0x47d0 drivers/usb/gadget/udc/dummy_hcd.c:2005
Allocated by task 10:
hidraw_connect+0x57/0x430 drivers/hid/hidraw.c:606
hid_connect+0x5bf/0x19d0 drivers/hid/hid-core.c:2277
hid_hw_start+0xa8/0x120 drivers/hid/hid-core.c:2387
corsairpsu_probe+0xd9/0x3c0 drivers/hwmon/corsair-psu.c:782
Freed by task 10:
hidraw_disconnect+0x4f/0x60 drivers/hid/hidraw.c:662
hid_disconnect drivers/hid/hid-core.c:2362 [inline]
hid_hw_stop+0x101/0x1e0 drivers/hid/hid-core.c:2407
corsairpsu_probe+0x327/0x3c0 drivers/hwmon/corsair-psu.c:826
Fix the problem by calling hid_device_io_stop() before calling
hid_hw_stop().
[groeck: Updated subject and description;
call hid_device_io_stop() only if IO has been started] |
| A memory corruption vulnerability exists when Windows Media Foundation improperly handles objects in memory. An attacker who successfully exploited the vulnerability could install programs; view, change, or delete data; or create new accounts with full user rights.
There are multiple ways an attacker could exploit the vulnerability, such as by convincing a user to open a specially crafted document, or by convincing a user to visit a malicious webpage.
The security update addresses the vulnerability by correcting how Windows Media Foundation handles objects in memory. |
