| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| Remote Development Extension for Visual Studio Code Remote Code Execution Vulnerability |
| Quantum Development Kit for Visual Studio Code Remote Code Execution Vulnerability |
| Visual Studio Code ESLint Extension Remote Code Execution Vulnerability |
| Windows Win32k Elevation of Privilege Vulnerability |
| Windows 10 Update Assistant Elevation of Privilege Vulnerability |
| Visual Studio Code Remote Code Execution Vulnerability |
| Microsoft Office Remote Code Execution Vulnerability |
| In the Linux kernel, the following vulnerability has been resolved:
net: slip: serialize receive against buffer reallocation
sl_realloc_bufs() replaces rbuff and updates buffsize while holding
sl->lock. slip_receive_buf() reads those fields and writes through rbuff
without holding the lock.
An MTU change can therefore race with receive processing. An MTU shrink
can expose the new smaller rbuff with the old larger bound, causing an
out-of-bounds write. A receive callback which already loaded the old
rbuff can instead continue writing after that buffer has been freed.
Serialize receive processing with sl_realloc_bufs() by holding sl->lock
while consuming each receive batch. |
| DirectX Elevation of Privilege Vulnerability |
| Windows Update Stack Setup Elevation of Privilege Vulnerability |
| In the Linux kernel, the following vulnerability has been resolved:
geneve: require CAP_NET_ADMIN in the device netns for changelink
A tunnel changelink() operates on at most two netns, dev_net(dev) and
the sticky underlay netns geneve->net. They differ once the device is
created in or moved to a netns other than the one the request runs in.
The rtnl changelink path checks CAP_NET_ADMIN only against dev_net(dev),
so a caller privileged there but not in geneve->net can rewrite a geneve
device whose underlay lives in geneve->net.
geneve_changelink() applies the new configuration against geneve->net:
geneve_link_config() and the geneve_quiesce()/geneve_unquiesce() pair
reopen the underlay sockets in that netns (geneve_sock_add() uses
geneve->net), so the same reasoning as the tunnel changelink series
applies here.
Gate geneve_changelink() with rtnl_dev_link_net_capable(), at the top of
the op before any attribute is parsed, matching ipgre_changelink() and
the rest of the "require CAP_NET_ADMIN in the device netns for
changelink" series.
Found by 0sec automated security-research tooling (https://0sec.ai). |
| In the Linux kernel, the following vulnerability has been resolved:
net/af_iucv: fix NULL deref in afiucv_hs_callback_syn()
afiucv_hs_callback_syn() allocates the child socket with GFP_ATOMIC.
If the allocation fails, nsk is NULL.
The connection-refused path is entered when the listen state check
fails, the accept backlog is full, or nsk is NULL. The code
unconditionally calls iucv_sock_kill(nsk) in that path.
iucv_sock_kill() does not accept a NULL socket pointer and immediately
dereferences sk via sock_flag(sk, SOCK_ZAPPED). When nsk is NULL,
calling iucv_sock_kill(nsk) results in a NULL pointer dereference.
Only call iucv_sock_kill() when a child socket was successfully
allocated. |
| In the Linux kernel, the following vulnerability has been resolved:
net/iucv: fix use-after-free of a severed iucv_path
af_iucv queues not-yet-received message notifications on iucv->message_q,
each holding a raw pointer to the connection's iucv_path. When the peer
severs the connection, iucv_sever_path() frees that path with
iucv_path_free() but leaves the notifications queued. A later recvmsg()
drains message_q via iucv_process_message_q() and hands the stale path to
message_receive() -- a use-after-free of the freed iucv_path.
Drop the queued notifications when the path is severed; once the path is
gone they can no longer be received. This also frees the notifications
leaked when a socket is closed with messages still queued. |
| In the Linux kernel, the following vulnerability has been resolved:
rbd: Reset positive result codes to zero in object map update path
In a reply message to an RBD request, a positive result code indicates
a data payload, which is not allowed for writes. While
rbd_osd_req_callback() already resets a positive result code for writes
to zero, rbd_object_map_callback() does not. This allows a corrupted
reply to an object map update to trigger the rbd_assert(*result < 0) in
__rbd_obj_handle_request(). This happens, because
rbd_object_map_callback() calls rbd_obj_handle_request() ->
__rbd_obj_handle_request() and passes this positive result code. From
__rbd_obj_handle_request(), rbd_obj_advance_write() is called, which
leaves the positive result code unchanged and returns true. Therefore,
the if(done && *result) branch is executed in __rbd_obj_handle_request()
and the assertion triggers.
This patch fixes the issue by adjusting the logic in the
rbd_object_map_callback() path. A positive result code for an object map
update is now reset to zero (similar to rbd_osd_req_callback()), and the
message is subsequently handled the same way as if the result code was
zero from the beginning. Additionally, a WARN_ON_ONCE() is added for
this case. |
| In the Linux kernel, the following vulnerability has been resolved:
gve: fix Rx queue stall on alloc failure
When the system is under extreme memory pressure, page allocations can
fail during the Rx buffer refill loop. If the number of buffers posted
to hardware falls below a critical low threshold and the refill loop
exits due to allocation failures, the queue can stall:
1. The device drops incoming packets because there are no descriptors.
2. Since no packets are processed, no Rx completions are generated.
3. Because no completions occur, NAPI is never scheduled, preventing
the refill loop from running again even after memory is freed.
This results in a permanent queue stall.
Resolve this by introducing a starvation recovery timer for each Rx queue.
If the number of buffers posted to hardware falls below a critical low
threshold, start a timer to periodically reschedule NAPI. Once NAPI runs
and successfully refills the queue above the threshold, the timer is
not rescheduled.
The threshold is set to 32 because a single maximum-sized Receive Segment
Coalescing (RSC) packet can consume up to 19 descriptors in the Rx path.
Lower thresholds (such as 8 or 16) would be insufficient to process a
complete maximum-sized RSC packet, risking packet drops or unexpected
hardware behavior under memory pressure. Setting the threshold to 32
guarantees a safe margin to handle at least one full RSC packet. |
| In the Linux kernel, the following vulnerability has been resolved:
mac802154: llsec: reject frames shorter than the authentication tag
llsec_do_decrypt_auth() computes the associated-data length for the
AEAD request as
assoclen += datalen - authlen;
where datalen is the number of bytes after the MAC header and authlen
(4, 8 or 16) is the length of the authentication tag. Nothing verifies
that the frame actually carries at least authlen payload bytes. A
secured frame whose payload is shorter than the tag makes
datalen - authlen negative; assoclen is then passed to
aead_request_set_ad() as an unsigned value close to 4 GiB, so
crypto_aead_decrypt() walks far off the end of the scatterlist that
only spans the real frame.
The frame is fully attacker-controlled and reaches this path from any
IEEE 802.15.4 peer in radio range. Reject frames whose payload is
shorter than the authentication tag before the subtraction.
Dynamically reproduced on a KASAN kernel as a general-protection-fault
in the AEAD scatterwalk, and the fix confirmed. |
| In the Linux kernel, the following vulnerability has been resolved:
pppoe: reload header pointer after dev_hard_header()
pppoe_sendmsg() saves a pointer to the PPPoE header before calling
dev_hard_header(). Device header callbacks are allowed to reallocate the
skb head, invalidating pointers into it.
This can happen when a send is blocked in copy_from_user() while the first
non-Ethernet port is added to an empty team device. The team's delegated
GRE header callback then expands the skb head. PPPoE subsequently writes
six bytes through the stale pointer into the freed head.
Reload the PPPoE header through the skb's network-header offset after
device header creation. pskb_expand_head() updates that offset when it
relocates the head. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amdgpu/vce: fix integer overflow in image size
Fix a security vulnerability where malicious VCE command streams
with oversized dimensions (e.g. 65536×65536) cause 32-bit integer
overflow, wrapping the calculated buffer size to 0. This bypasses
validation and allows GPU firmware to perform out-of-bound memory
access.
The fix uses 64-bit arithmetic to detect overflow and rejects
invalid dimensions before they reach the hardware.
V2: remove redundant check
V3: modify max height value
V4: remove size64
(cherry picked from commit cbe408dba581755ad1279a487ec786d8927d778d) |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amdgpu: fix division by zero with invalid uvd dimensions
When width or height is less than 16, width_in_mb or height_in_mb
becomes 0, leading to fs_in_mb being 0. This causes a division by
zero when calculating num_dpb_buffer in H264 and H264 Perf decode
paths.
Add validation to reject frames with width < 16 or height < 16
before performing any calculations that depend on these values.
V2: Format change - move up all vaiable definitions.
V3: Use warn_once to avoid spam.
(cherry picked from commit 3e41d26c70b0a459d041cc19482a226c4b7423cb) |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amdgpu: invoke pm_genpd_remove() before freeing genpd
Call pm_genpd_remove() to unregister from global list prior to releasing
acp_genpd memory, and clear the pointer after free.
(cherry picked from commit cd8650d7a91ee8b768e202354672553faa5cc1f2) |
